Home » Products » Pneumatic Grippers » AGW-250-2 Wide Body Series Parallel Gripper 1.500″ Stroke

AGW-250-2 Wide Body Series Parallel Gripper 1.500″ Stroke

Features & Benefits

Ultra high gripping force to weight ratio due to four opposing independent pistons that direct power to the jaws.
True parallel jaw motion for easy tooling.
Units are permanently lubricated for non-lube air operation, allowing for OSHA compliance.
Piston seals are quad-ring type for long service life.
Large jaw support shafts are guided through the full width of the main body.
Proximity switches are available to monitor open and closed position of the jaws.
Series AGW-250 is fully field repairable for cost savings and minimum down time.
Non-synchronous versions allow the gripper’s jaws to comply to the part’s centerline versus the gripper’s centerline.

Measurement Type

Sensor Options

Sensor Type

Sensor Connector

Non-Synchronized Option

Clear

Design: Parallel, Double Acting, Synchronized Jaws

Stroke: 1.50 in [38.1 mm]

Thrust Force @ 80 PSI [5.5 BAR]
Closing: 20 lbs [89 N]
Opening: 26 lbs [115 N]

Time:
Close: 0.2 sec [0.2 sec]
Open: 0.2 sec [0.2 sec]

Pressure Range:
Low/High 20-120 PSI [1.7-8 BAR]

Temperature Range:
Low/High -20°/180°F [-28°/80°C]

Side Play:
± 0.001 [.03 mm]

Repeatability from Center:
± 0.002 [.06 mm]

Loading Capacity: Static – Dynamic

Max Tensile T
50 lbs 10 lbs
[230 N] [44.5 N]

Max Compressive C
50 lbs 10 lbs
[230 N] [44.5 N]

Max Moment Mx
100 in/lb 20 in/lb
[11.3 Nm] [2.3 Nm]

Max Moment My
150 in/lb 30 in/lb
[17 Nm] [3.4Nm]

Max Moment Mz
100 in/lb 20 in/lb
[11.3 Nm] [2.3 Nm]

Material: High Strength,Hard Coated aluminum bronze alloys, Steel

Weight: 11 oz [311 g]

Piston Diameter: .500 in x 4 [12.7 mm]