Home » Products » Pneumatic Grippers » AGW-375-2 Wide Body Series Parallel Gripper

AGW-375-2 Wide Body Series Parallel Gripper

Features & Benefits

Ultra high gripping force to weight ratio due to four opposing independent pistons that direct power to the jaws.
True parallel jaw motion for easy tooling.
Units are permanently lubricated for non-lube air operation, allowing for OSHA compliance.
Piston seals are quad-ring type for long service life.
Large jaw support shafts are guided through the full width of the main body.
Proximity switches are available to monitor open and closed position of the jaws.
Series AGW-375-2 is fully field repairable for cost savings and minimum down time.
Non-synchronous versions allow the gripper’s jaws to comply to the part’s centerline versus the gripper’s centerline.

Measurement Type

Sensor Options

Sensor Type

Sensor Connector

Non-Synchronized Option

Clear

Design: Parallel, Double Acting, Synchronized Jaws

Stroke: 2 in [50.8 mm]

Gripping Force @ 80 PSI Per Jaw [5.5 BAR]
Closing: 36 lbs [160 N]
Opening: 38 lbs [170 N]

Time:
Close: 0.3 sec [0.3 sec]
Open: 0.3 sec [0.3 sec]

Pressure Range:
Low/High 20-120 PSI [1.7-8 BAR]

Temperature Range:
Low/High -20°/180°F [-28°/80°C]

Side Play:
± 0.001 [.03 mm]

Repeatability from Center:
± 0.002 [.06 mm]

Loading Capacity: Static – Dynamic

Max Tensile T
100 lbs 20 lbs
[445 N] [89 N]

Max Compressive C
100 lbs 20 lbs
[445 N] [89 N]

Max Moment Mx
175 in/lb 35 in/lb
[19.5 Nm] [4 Nm]

Max Moment My
250 in/lb 50 in/lb
[28 Nm] [5.6Nm]

Max Moment Mz
175 in/lb 35 in/lb
[19.5 Nm] [4 Nm]

Material: High Strength,Hard Coated aluminum bronze alloys, Steel

Weight: 2 lbs [9 kg]

Piston Diameter: .625 in x 4 [15.8 mm]