AGW-625-4 Wide Body, Synchronous / Non-Synchronous Series Parallel Gripper

Features & Benefits

Ultra high gripping force to weight ratio due to four opposing independent pistons that direct power to the jaws.
True parallel jaw motion for easy tooling.
Units are permanently lubricated for non-lube air operation, allowing for compliance with OSHA regulations.
Piston seals are quad ring type for long service life.
Large jaw support shafts are guided through the full width of the main body.
Proximity switches are available to monitor open and closed position of the jaws.
The AGW Series is fully field repairable for cost savings and minimum down time.
Non-synchronous versions allow the grippers jaws to comply to the parts centerline versus the grippers centerline.

Measurement Type

Sensor Options

Sensor Type

Sensor Connector

Non-Synchronized Option

Clear

Design: Parallel, Double Acting, Synchronized Jaws

Stroke: 4 in [101.6 mm]

Gripping Force @ 80 PSI Per Jaw [5.5 BAR]
Closing: 130 lbs [578 N]
Opening: 132 lbs [587 N]

Time:
Close: 0.3 sec [0.3 sec]
Open: 0.3 sec [0.3 sec]

Pressure Range:
Low/High 20-120 PSI [1.7-8 BAR]

Temperature Range:
Low/High -20°/180°F [-28°/80°C]
Side Play:
± 0.001 [.03 mm]

Repeatability from Center:
± 0.002 [.06 mm]

Loading Capacity: Static – Dynamic

Max Tensile T
1300 lbs 150 lbs
[5700 N] [667 N]

Max Compressive C
1300 lbs 150 lbs
[5700 N] [667 N]

Max Moment Mx
1100 in/lb 120 in/lb
[124 Nm] [13.5 Nm]

Max Moment My
1500 in/lb 130 in/lb
[170 Nm] [14.7Nm]

Max Moment Mz
1100 in/lb 120 in/lb
[124 Nm] [13.5 Nm]

Material: High Strength,Hard Coated aluminum bronze alloys, Steel

Weight: 8 lbs [3.6 kg]

Piston Diameter: 1.625 in [41.3 mm]